Calibration

Calibration of measuring equipment is essential for many businesses.

Abtest Limited offers a comprehensive Traceable calibration service.

Abtest Calibration guide Right click on link and select 'Save Target As' to save guide.

Click here to see other service guides available.

Calibration

Facilities are available for the calibration of Electrical and Mechanical instruments against references that are traceable to National Standards.

The calibration system meets the requirements of  the approval bodies for Abtest Limited. On site and off site calibration service is available, depending upon customer requirement.

Electrical

DC voltage, AC voltage,
DC current, AC current,
DC resistance,
Capacitance, Inductance,
Frequency.

Mechanical

Force, Torque,  Tensile strength,
Linear, Weight,
Rubber hardness,
Thread calibration.

 

Physical

Temperature, Humidity,
Pressure & Vacuum.

Traceable Calibration Capability

AC Test Set Plug Thread Gauge(Taper)
Accelerator Power Supply
Ammeter AC+ DC Precision Balls(Ball Bearings)
Anemometer Precision Rollers
Angle Plate Pressure Gauge
Caliper Profile Gauge
Capacitance Meter Programmable Switch Box
Chart Recorder Protractor
Clamp Meter Radius Gauge
Combination Set Ratio Box
Comparator Ratio Tester
Contact Resistance Meter RCD/RCCB Tester
Current Probe Resistance Decade
Current Shunt Resistance Meter
Current Transformer Ring Gauge (Parallel)
Depth Gauge Ring Gauge (Taper)
Dial/Digital Indicator Ring Thread Gauge (Parallel)
Dynometer Ring Thread Gauge (Taper)
Electric Screwdriver Rule
Feeler Gauge Set Salt Fog Chamber
Flash Tester Scope meter
Force Gauge Shadowgraph
Freezer Shore Hardness Machine
Frequency Counter Sine Bar
Frequency Generator Sine Centre
Gap Gauge Sine Table
Gauge Block Set Solder Flow System
Height Gauge Solder Pot/Bath
High Voltage Meter or Probe Solder Temp Monitor
High Voltage Puncture Tester Soldering Iron
Hotplate Spring Balance
Humidity Chamber Square (Engineers)
Hygrometer/Humidity Recorder Straight Knife Edge
Immersion Bath Stroboscope
Inductance Meter Surface Plate
Infra Red Thermometer Tape Measure
Insulation Tester Temp/Voltage Convertor
LCR Meter Tension Meter
Length Bar Thermal Cycling Chamber
Level Thermohygrometer
Loop Tester Thermometer/Controller
Low Ohm Adaptor Thermometer/Probe
Low Ohmmeter Thread Parallels
Manometer Thread Pitch Gauge
Measuring Microscope Torque Machine
Megohmmeter Torque Screwdriver
Micrometer Torque Spanner
Micro-ohmmeter Torque Watch
Milliohmmeter Torque Wrench
Multimeter Vacuum Gauge
Optical Tachometer Vee Blocks
Oscilloscope Vibration Meter
Oven Voltage Calibrator
Parallels Voltmeter
PAT Tester Watt Hour Meter
ph Meter Wattmeter
Pin Gauge Weighing Scales
Plug Gauge (Parallel) Weights (Set)
Plug Gauge (Taper) Wrist Strap Checker
Plug Thread Gauge(Parallel)

[Calibration]  [Investigative Test]  [In Circuit Test]  [Functional Test]  [Vision Systems]  [Climatic Test]  [Salt Spray]  [Humidity]  [Temperature]  [Gas Corrosion]  [Fluids Test]  [Vibration Test]  [Shock Test]